ApplicationThis option will enable you to increase the number of motorized tools available at the guide bush by installing two on platen 1. This new S6 motorization complements the S2 motorization already installed on platen 2.CommentIncreasing the turning working positions at the guide bush is achieved by using the existing turning units (1600 and 1690) on the other machine tool systems. Modularity is thereby guaranteed. This facility replaces the need to add high-frequency, low- power turning units. Considerable increases in production are thus achieved during the simultaneous cross-drilling operations using the rear platen x2/y2. This new option will not allow left rotation (no tapping) or synchronization with the other motorizations.CompatibilityThis option is available ex-works. TORNOS engineers will perform a retrofit on the DECO 20a and 26a. Once installed, it will not be possible to dismantle the motorization. Located on the tool-holder plate of the front screw die, the motorization causes no stress to the platen tool positions - i.e. the 5 positions. However, the NSK high-frequency spindles (options 2000 and 2100) can no longer be mounted on the screw die X1/Y1.
THINK PARTS THINK TORNOS ascl.com | |||||||||||||||||||||||||||||||||||||||||||||||
|
|
 |
 |
|
|
TORNOS SA Rue Industrielle 111 CH-2740 Moutier Switzerland |
Tel.: +41 (0)32 494-4444 Fax: +41 (0)32 494-4903 www.tornos.com |
|